CodeWarrior for MCUのトピックMULTILINK UNIVERSAL Rev.B is not working

MULTILINK UNIVERSAL Rev.B is not working

vigneshkumarp — Mon, 09 Jan 2017 08:36:48 GMT

Hi, I am using MULTILINK UNIVERSAL Rev.B. The programmer is working at some time not at most times.

When I used to program it works fine for some times but after that it stops working.

The same target board is working fine with another MULTILINK UNIVERSAL Rev.C.

What should I do now to rectify this problem?

Re: MULTILINK UNIVERSAL Rev.B is not working

jorge_a_vazquez — Thu, 12 Jan 2017 00:03:21 GMT

Hi VIGNESHKUMAR P

Could you tell us what CodeWarrior version, OS and MCU are you using? Also, Have you tried to installed P&Emicro drivers in your IDE?

Regards

Jorge Alcala

Re: MULTILINK UNIVERSAL Rev.B is not working

vigneshkumarp — Thu, 12 Jan 2017 06:27:53 GMT

Hi Jorge Antonio Alcala Vazquez,

Am using CW 10.6 under windows 7 and controller is KINETICS MKV10Z32VLC7(Using PORT-B in multilink). Yes I have Installed the latest P&E micro drivers.

And now the Universal Multilink is programming good for 5 to 10 times but afterwards it stops and shows the above error.

Regards,

Vigneshkumar P