I can’t send flash file to target using CW for MCU v10.2

johanforssen — Wed, 07 May 2014 10:56:49 GMT

I can’t send flash file to target, K10 (using CW for MCU v10.2, and a P&E multilink device). I can do exactly the same on my old computer, but not with my new one. I get the errormessage “Error: Couldn't stop the target. Can't stop the target.

An error occurred while trying to write memory. The Debugger is not connected to the P&E device(ARM GDI Protocol Adapter)”

Any ideas?

Re: I can’t send flash file to target using CW for MCU v10.2

ZhangJennie — Thu, 08 May 2014 08:04:03 GMT

hi Johan.

please try below suggestion:

1. remove .metadata folder in your current workspace, then restart CW10 test your project again.

2. CW10.2 is very old, please try CW10.6 instead.

https://www.freescale.com/webapp/sps/site/prod_summary.jsp?code=CW-MCU10&tid=CWH

please note: CW10.6 and CW10.2 can't share the same workspace.

====================================================

this answer is for you. if it helps, please click on "correct answer" button. thanks!

Best Regards,

ZhangJun

topic I can’t send flash file to target using CW for MCU v10.2 in CodeWarrior Development Tools

I can’t send flash file to target using CW for MCU v10.2

Re: I can’t send flash file to target using CW for MCU v10.2