topic Re: Exclamation marks in Device manager, Failure message in CodeWarrior in CodeWarrior Development Tools

Exclamation marks in Device manager, Failure message in CodeWarrior

laszlo_torok — Tue, 30 Jul 2019 14:06:24 GMT

Hi !
I connected an S9S12GA128 uC to the Multilink Universal FX debugger and installed a CodeWarrior CWS12v5.2 on my W10 Op.Sys in order to flash it. The PC has not recognized the debugger appropriate because in the device manager can any exclamation marks be seen. I did any times driver update but the situation is the same:

In CodeWarrior after loading Projekt File and doing 'Debug' there is next message coming:

What would you recommend to do ?

Thanks.

Laszlo

Re: Exclamation marks in Device manager, Failure message in CodeWarrior

Alice_Yang — Wed, 31 Jul 2019 07:42:36 GMT

Hello Laszlo,

Please try to install latest PEmicro drivers

http://www.pemicro.com/downloads/download_file.cfm?download_id=53

and firmware for S12(X) :

http://www.pemicro.com/downloads/download_file.cfm?download_id=346

There is a similar question you can have a look:

How to use P&E USB Multilink with 9S12XE and CW 5.2?

Have a great day,
TIC

-------------------------------------------------------------------------------
Note:
- If this post answers your question, please click the "Mark Correct" button. Thank you!

- We are following threads for 7 weeks after the last post, later replies are ignored
Please open a new thread and refer to the closed one, if you have a related question at a later point in time.
-------------------------------------------------------------------------------

Re: Exclamation marks in Device manager, Failure message in CodeWarrior

laszlo_torok — Wed, 31 Jul 2019 12:51:57 GMT

Hello Alice,

thanks for the suggestions, in the end the firmware update has helped.

The new device 'pemicrowindrvr' in Jungo appeared and the exclamation marks disappeared except WinDriver in the Device Manager, see below:

It was possible to flash the uC.

Thanks once more, regards:

Laszlo

Re: Exclamation marks in Device manager, Failure message in CodeWarrior

Alice_Yang — Thu, 01 Aug 2019 03:39:22 GMT

Hello Laszlo,

Ok, good to hear it can work.

Have a great day,
TIC

-------------------------------------------------------------------------------
Note:
- If this post answers your question, please click the "Mark Correct" button. Thank you!