CodeWarrior Development ToolsのトピックRe: CodeWarrior

CodeWarrior

new1979 — Fri, 04 Jan 2019 06:30:45 GMT

CodeWarrior USB TAP install drive program ，CodeWarrior USB TAP still red light glitter，why？

Re: CodeWarrior

ZhangJennie — Wed, 09 Jan 2019 02:10:11 GMT

Hi ,

What's your chip part number?

Jennie Zhang

Re: CodeWarrior

new1979 — Wed, 09 Jan 2019 03:30:33 GMT

MC56F8345VFGE

发自我的 iPhone

在 2019年1月9日，10:11，ZhangJennie <admin@community.nxp.com> 写道：
NXP Community
Re: CodeWarrior
reply from ZhangJennie in CodeWarrior Development Tools - View the full discussion
Hi ,
What's your chip part number?
Jennie Zhang
Reply to this message by replying to this email, or go to the message on NXP Community
Start a new discussion in CodeWarrior Development Tools by email or at NXP Community
Following Re: CodeWarrior in these streams: Inbox
This email was sent by NXP Community because you are a registered user.
You may unsubscribe instantly from NXP Community, or adjust email frequency in your email preferences

Re: CodeWarrior

ZhangJennie — Thu, 10 Jan 2019 08:35:25 GMT

Hi Fangfeng,

USB TAP driver is included in CodeWarrior install folder. But please note, if you use 64bit win7/win10, I suggest you use CW10.x or CW11.x for programming. Classic CodeWarrior 8.3 doesn't support 64bit win7/win10 platform.

when you connect USB TAP with PC only, TX/RX is blinking (red), this is normal.

after downloading code, you should see TX/RX blinking (yellow and green), RUN/PAUSE led is on (red)

Have a great day,
Jun Zhang

-----------------------------------------------------------------------------------------------------------------------
Note: If this post answers your question, please click the Correct Answer button. Thank you!
-----------------------------------------------------------------------------------------------------------------------