topic Re: target task greyed out in CodeWarrior Development Tools

target task greyed out

hawk — Fri, 23 May 2014 19:30:05 GMT

I am getting the error "Error setting debug context for run configuration Active Debug Context".

Some reading and I came "target configuration", which is greyed out. So I can't check it or change it.

Can anyone help me with the above error. I am using USB Multilink universal to (attempt) to program a MC9SO8AW32.

I have never seen BKGD go low, will check clock now. Ok, found one problem, needed b+ on another trace. Processor running.

But now I have these two new errors: According to the forum, a-lot of people do. Followed the suggestions in those posts and those pins seem ok. BKGD, VDD, Gnd, and reset.

Much Thanks,

David

Re: target task greyed out

Rick_Li — Fri, 13 Jun 2014 08:42:20 GMT

Hi David,

Please accept my apology for the time delayed to get back to you on this issue, I was heavily backlogged!

regarding this problem, if it still there, then, could you mind upload an screen-shot to here for further investigating?

Re: target task greyed out

hawk44 — Fri, 13 Jun 2014 15:35:20 GMT

Thank your for your kindness.

Problem resolved, erased, re-flashed.

Thank your for at least replying, I was under pressure to get the job done by xx time and I am new to CodeWarrior,

It was about to drive me nuts, seemed like the simplest things didn't work.

But we got it done, a day ahead of time. :smileyhappy:

Thanks again for your reply. Have a great day and weekend

David