CodeWarrior Development Tools中的主题 Codewarrior 5.9 for S12 debugger

Codewarrior 5.9 for S12 debugger

sufree — Mon, 03 Jul 2017 02:54:54 GMT

Hi,

I use the Codewarrior 5.9 for S12 to debugger,when i click Start/Continue button to RUN the code ,but it can't run .As shown in the picture below.it just can single step .Does anyone know the reason?

Re: Codewarrior 5.9 for S12 debugger

ZhangJennie — Mon, 03 Jul 2017 06:48:46 GMT

Hi,

From your second picture, your run button is grey out, so your program already runs.

Why did you say "it can't run"?

Have a great day,
Jennie Zhang

-----------------------------------------------------------------------------------------------------------------------
Note: If this post answers your question, please click the Correct Answer button. Thank you!
-----------------------------------------------------------------------------------------------------------------------

Re: Codewarrior 5.9 for S12 debugger

sufree — Mon, 03 Jul 2017 08:39:03 GMT

Hi,

After I click Start/Continue button , then show in the second picture ."it can't run" means the code can't run to the breakpoint i set ,still as the second picture show.

thank you

Re: Codewarrior 5.9 for S12 debugger

ZhangJennie — Thu, 06 Jul 2017 04:25:25 GMT

Hi,

The most common reason for this problem is that the code where you set breakpoint is optimized or your program didn't run there. Please check this point.

If still has problem, please send your demo project and let me know where to set breakpoint to reproduce your problem. Thanks.

Have a great day,
Jennie Zhang