Classic/Legacy CodeWarrior中的主题 Re: "Internal error: DoSuspend" message

"Internal error: DoSuspend" message

CONDER — Wed, 15 Nov 2006 11:24:20 GMT

Hi, dear all,

I have a question on CW debugging.
While debugging under CW, sometimes my program gets "frozen", i.e., it stops execution but not return. Pressing "break" botton gives me following message:
Internal error: DoSuspend
Thread error

Could someone give me a hint what may cause this problem? Thanks in advance.

Regards,

CONDER

Re: "Internal error: DoSuspend" message

CrasyCat — Wed, 15 Nov 2006 20:08:08 GMT

Hello

Which CPU are you targeting (HC08, HC12, Coldfire, ...)?

Which version of CodeWarrior are you using ?

To retrieve that info:

- Start IDE

- Select Help -> "About Freescale CodeWarrior"

- Press on "Installed Products"

- You will see CodeWarrior version info into the title bar.

Which cable are you using to connect to your target board( Multilink, USBTAP, ...)?

CrasyCat

Re: "Internal error: DoSuspend" message

CONDER — Thu, 16 Nov 2006 09:45:55 GMT

Hi, CrasyCat,

Thanks for you reply.

I'm using MSC8122 DSP and using USBTAP to connect to the board.
The CodeWarrior version is:
CodeWarrior StarCore Compiler (Windows), Engineering Build 18
CodeWarrior Development Studio for Freescale StarCore DSP Architectures, Version 2.7.2, Update Build 2
IDE Version: 5.7.0 Build 1996

Regards,

CONDER

Re: "Internal error: DoSuspend" message

CrasyCat — Thu, 16 Nov 2006 19:05:41 GMT

Hello

Only case I get this message was when I was using a wrong register configuration file in my project.

Make sure the configuration file you use in the SC100 Debugger Target panel is correct.

If this does not help, I would recommend you to submit a service request through our web page to get support people get a look at it.

Specify board, CodeWarrior version and connection you are using when submitting the SR..

CrasyCat