USB TAP problem "CCSProtocolPlugin : Unknown protocol error"

flyboy — Sat, 15 May 2010 23:27:12 GMT

I have installed CW_DSC56800E_8.3_Special.exe on a laptop. I can not get my USB TAP rev E to talk to a MC56F8006DEMO board.

This comptete setup works fine on my desktop.

I have researched these Forums and have tried everything and nothing has helped.

Re: USB TAP problem "CCSProtocolPlugin : Unknown protocol error"- THE FIX

flyboy — Sat, 05 Jun 2010 05:51:51 GMT

Support helped me with this.

This is what support suggested:

Thanks for the request.
First you can have several installation on the same PC.
In your case you can have the DSC V8.2.3 and DSC V8.3 installed.
There is only one restriction: install them on separate folder.

Can you check if the USBtap is correctly installed and recognized ?
Plug the USBTap on the PC, launch the CCS and type:
show com
delete all
show cc
config cc utap
show wdv
show cc

Basically the problem was the "config cc utap" is what fixed everything to work. Don't forget to save the config after you do this.

Thanks support!

Classic/Legacy CodeWarriorのトピックRe: USB TAP problem "CCSProtocolPlugin : Unknown protocol error"- THE FIX

USB TAP problem "CCSProtocolPlugin : Unknown protocol error"

Re: USB TAP problem "CCSProtocolPlugin : Unknown protocol error"- THE FIX