topic Breakpoint at main function after Loading Code in Classic/Legacy CodeWarrior

Breakpoint at main function after Loading Code

sebasira — Thu, 16 Aug 2012 02:19:03 GMT

Hi all!

When code is loaded to the MCU, it runs until main function and then halt there.... Well, I don't know what I've change, it doesn't do it anymore... If I recall correctly it was related to .ini file.

I'm using CW 4.6

Thanks!

Re: Breakpoint at main function after Loading Code

CrasyCat — Thu, 16 Aug 2012 13:04:20 GMT

Hello

Can you try the following:

- Start debugging the usual way

- In Hi-WAVE debugger select File > Configuration

- Switch to the Load tab.

- Make sure Run after Successful load is checked

- Check Stop at Function and specify main in the edit box.

- Select File > Save Configuration

-Close the debugger and restart it. Application should run to main.

CrasyCat

Re: Breakpoint at main function after Loading Code

sebasira — Thu, 16 Aug 2012 18:33:16 GMT

Thank you very much CrasyCat! That solve my problem!