Classic/Legacy CodeWarriorのトピックRe: CW8/DemoBoard56F8357/ProcessorExpert - SCI Communication

CW8/DemoBoard56F8357/ProcessorExpert - SCI Communication

howdeterminepwm — Wed, 17 Oct 2007 01:40:11 GMT

Hi all,
more one message in forum... hehe Sorry, I am newBie in Embed Systems.
I need test SCI communication in demoBoard56F8357, using Processor Expert. I looked messages in forums with the question SCI communication and has any question about SCI how test? I purschase the FreeMaster for test SCI correct? How i made this? I need of other aplication? or i must use HyperTerminal?
What method i must trying? One example of how test sci please, and sorry for mine ignorance.

obs: I connect the Db09 in pc and demoboard (OFF of voltage) and all the leds of demoboard is ON, this correct? Now i must ON voltage of demoboard and debug a project with Bean PC_Master? And after?? How read serial port in pc? Thanks, very thanks.....

Re: CW8/DemoBoard56F8357/ProcessorExpert - SCI Communication

howdeterminepwm — Wed, 17 Oct 2007 22:51:22 GMT

Hi all,
new facts, i connected rs232 in the demoboard and in PC. Used the CW for open Project Motor Control e open this project in FreeMASTER. I Order connect and response this error in freeMASTER:

Can not detect the board information! The communication
will be paused. Error code: 0x80000101

What's problem? Thankss

Re: CW8/DemoBoard56F8357/ProcessorExpert - SCI Communication

trytohelp — Mon, 22 Oct 2007 20:00:59 GMT

Hi,

There is a process to use FreeMaster.

This was an answer I sent to a customer about FreeMaster (older PCMaster).

You would like to use PCMaster.

This tool is provided by Freescale and integrated in our installation.

You can try a small example by creating a project using Processor Expert (PE) for the DSP56F8357.

PE has a bean managing the PCMaster.

Attached to this email you will find an example. I can not test it on this board because I don't have the EVM for this processor but

it's working for another derivative (8346).

To test it you must:

- open the project sent,

- compile the code without optimization,

- start the application.

Now the debugger is started and stopped of the main function.

For PCMaster:

- start the tool,

- click on Project | Option,

- check the Comm,

- In Map Files, in the Default symbool file, select the elf file generated by CW and Elf/dwarf as file format.

Close this dialog.

- select the Name field and with the pop-up select "Create new watched var ..."

- in the variable menu do:

- select the uiZaehler_ms variable in the "Address" field,

- valid by ok.

- Repeat the operation for uiQuadrat_ms and uiOffset_ms,

- Select New project and with the pop-up menu select Create scope,

- in the scope dialog, you must:

- click on setup and select your variables. Refer to the jpeg attached.

- select New scope.

- Now you can save the config as a .pmp file.

- Click on Stop and valid by cancel.

Now, Pc Master is ready.

Go to CW and run the application.

On PC Master you can see the info concerning the 3 variables

    static unsigned int uiZaehler_ms;
    static unsigned int uiQuadrat_ms;
    static unsigned int uiOffset_ms;

Hope this will help you.

Pascal

PC_master1.jpg

1_57828054_example1.zip

Message Edited by t.dowe on 2009-10-15 05:36 PM