topic ELF is not in expected HALT mode in Classic/Legacy CodeWarrior

ELF is not in expected HALT mode

sai — Tue, 28 Aug 2007 02:09:07 GMT

When I try to step into next instruction or somtimes put a break point or do a hard reset from the CodeWarrior IDE I get a message that says:

ELF is not in expected HALT mode or
ELF is not in expected STOP mode

Any idea what this means. Thanks for any inputs.

I'm using USB TAP to connect to target, with a default clock speed of 4.03 MHz. CodeWarrior version 8.7.

-Sai

Message Edited by sai on 2007-08-27 08:13 PM

Message Edited by sai on 2007-08-27 08:15 PM

Re: ELF is not in expected HALT mode

trytohelp — Wed, 29 Aug 2007 16:03:52 GMT

Hi,

Can you please give us the tool version used ?

To do that you must:
* CW:
Start the IDE and click on Help | About Metrowerks CodeWarrior.
Click on Installed Products
Provide us all info displayed.
Or you can save them in a txt file.

Pascal

Re: ELF is not in expected HALT mode

sai — Thu, 30 Aug 2007 06:10:36 GMT

Another freescaler has posted a reply to this question in CodeWarrior for ColdFire and Power forum.

Thanks anyway.
-Sai

Re: ELF is not in expected HALT mode

scancath — Fri, 14 Nov 2008 02:36:24 GMT

Hi,

I'm trying to connect USB TAP to our custom board. I'm getting the following messages

" Failed to freeze at negation of hreset" and "ELF is not in expected HALT mode" messages.

I presume some thing fundamental is wrong with this board. Any pointers on when I would see this type of messages?

Thanks a bunch,

Prasad

Re: ELF is not in expected HALT mode

CrasyCat — Mon, 24 Nov 2008 18:58:45 GMT

Hello

I would recommend you to create a new post for that issue.

Make sure you specify which target and version of CodeWarrior you are using.

To retrieve that info:
- Start CodeWarrior
- Select Help -> About Freescale CodeWarrior
- Click on "Install Products"
- CodeWarrior version used is displayed on top in the Installed Products dialog.

CrasyCat