topic Re: Next step after compiling? in Classic/Legacy CodeWarrior

Next step after compiling?

DoktorLekar — Fri, 02 Jun 2006 20:42:03 GMT

I have successfully compiled code for 56f8322 and now what?

Where is that file i should upload to the microcontroller, i expected it to

be in hex format?

Can i use wiggler to program the microcontroller?

Thanks!

Re: Next step after compiling?

J2MEJediMaster — Mon, 05 Jun 2006 20:18:33 GMT

Are you using the command line tools?

If you're building the program from within the CodeWarrior IDE, you should be able to select Debug under the Project menu and the IDE will automatically download the file to the processor for you. (This assumes that you've picked a hardware target to build to, and not the emulator.)

---Tom

Re: Next step after compiling?

DoktorLekar — Tue, 06 Jun 2006 03:19:32 GMT

The thing is that i only have this codewarrior and microcontroller (56f8322) nothing else.

I need some kind of programmer to program the chip from s-record file generated by compiler.

What would you suggest me what to use , which programmer, I am willing to make one of my own but i dont understand the protocol (JTAG), because comercial programmers are too expensive.

Thank you for your support!

Re: Next step after compiling?

J2MEJediMaster — Tue, 06 Jun 2006 20:28:06 GMT

Under the CodeWarrior Products choice on the left side of this Web page, pick 56800/eHybrid from the drop-down menu. On this page you'll find a lot of documentation. Under the User Guide section, you'll find the 56800E Flash Programmers Guide. Download the Acrobat file and read that. Return to this same page, and scroll downwards until you find the Emulators/Programmers/Wigglers section and you should be able to choose a programmer device suitable for your setup.

---Tom