ColdFire/68K Microcontrollers and ProcessorsのトピックRe: CF Flasher - Could not initialize BDM device

CF Flasher - Could not initialize BDM device

skenaka — Fri, 22 Sep 2006 09:40:23 GMT

I have M52235EVB and CW6.3 installed. I can compile "Hello World" code and download and debug it through USB_ML_CFE rev.C in CW without a problem. However, when I try to use CF Flasher(3.1) to write the NicheLite S19 code to the board, it complains "Could not initialize BDM device."

Target configuration is set to M52235EVB and BDM Communication is set to PE_USB_ML,a nd others remain defaults
Updated the driver to the latest one (windrvr6.sys ver.7.0.0, 3/21/05) from P&E, passed the P&E's test
Works fine with CW
Not using CW and CF Flasher at the same time, even tried right after a reboot

Any idea where might be the problem?

Thanks,

- skenaka

Re: CF Flasher - Could not initialize BDM device

Stan — Fri, 22 Sep 2006 14:34:00 GMT

try to add this dll in windows\system32

Regards,

Stan

unit_cfz.zip

Message Edited by t.dowe on 2009-10-21 02:38 AM

Re: CF Flasher - Could not initialize BDM device

skenaka — Sat, 23 Sep 2006 01:14:42 GMT

Hi Stan

Problem solved. Thanks a lot!

I found two files with the same file name in 'CW\bin' and 'CW\Third_party\CF_Flasher' directories, but not in seperately installed CF Flasher directory. So probably should copy the unit_cfz.dll to the new CF Flasher directory. (copy to system32 works fine, too!)

Thanks again.

- skenaka