topic ADC problem in ColdFire/68K Microcontrollers and Processors

ADC problem

dgipling — Fri, 04 Dec 2009 19:41:44 GMT

Hi, I am pretty new to ColdFire CPU and have just started to work with it. I want to use the ADC converter to do some simple measurments. I have tried the following code but all that is printed is 0 for all channels.

           MCF_ADC_CTRL2 = 0x1F; //slowest possible clock

           MCF_ADC_POWER &= ( MCF_ADC_POWER_PD0 |   //power up ADC
                  MCF_ADC_POWER_PD1 |
                  MCF_ADC_POWER_PD2 );

           MCF_GPIO_PANPAR = 0xff;   //use adc on AN0-7

           MCF_ADC_CTRL1 = 0x2000;  //start convertion single ended once seqential

           while ( MCF_ADC_ADSTAT & 0xc000 ); //wait till convertions ready

           for ( i = 0; i < 8; i++ )
           printf ( "ADC%d: %x\n", i, MCF_ADC_ADRSLT(i));

The CPU is a 52233 using a 25MHz Xtal multipledied with 2 by the PLL to be able to use fast ethernet.

Re: ADC problem

mjbcswitzerland — Fri, 04 Dec 2009 22:23:04 GMT

Check the following line:

MCF_ADC_POWER &= ( MCF_ADC_POWER_PD0 | MCF_ADC_POWER_PD1 | MCF_ADC_POWER_PD2 );

These bits are '1' as default (powered down) so to power them up you need to set them to '0'. That is you need to use &= ~(...)

If you need complete ADC support, check out the following: http://www.utasker.com/forum/index.php?topic=280.0. The utasker simulator supports the ADC module and can be used to test threshold triggering interrupts etc...It also automatically optimises the power consumption of the module depending on its exact usage.

Regards

Mark

www.uTasker.com
- OS, TCP/IP stack, USB, device drivers and simulator for M521X, M521XX, M5221X, M5222X, M5223X, M5225X. One package does them all - "Embedding it better..."

Re: ADC problem

dgipling — Fri, 04 Dec 2009 22:47:03 GMT

Thanks a lot Mark, I have to read the data sheet more detailed I understand. I had to add another line of code after I had powered up the ADC by addin the code

while (MCF_ADC_POWER & (MCF_ADC_POWER_PSTS0 |

MCF_ADC_POWER_PSTS1 | MCF_ADC_POWER_PSTS2))
{};

Re: ADC problem

mjbcswitzerland — Fri, 04 Dec 2009 23:04:21 GMT

Yes, this is also true.

Regards

Mark

Re: ADC problem

TVNAIDU — Tue, 14 Sep 2010 08:37:06 GMT

I am using only AN7 bit for ADC, before checking ADSTAT, I need to start sampling once voltage available on AN7, how can I start sampling?. what register I need to set to start sampling?.