ColdFire/68K Microcontrollers and ProcessorsのトピックRe: MCF5485 : slice timers

MCF5485 : slice timers

ericp — Wed, 29 Aug 2007 14:38:11 GMT

Hi,

I am working with Coldfire 5485 and I want to use SLT0 slice timer in Interrupt Enable Mode.

But I never run the handler of the interrupt when SCNT0 reaches 0 ...

Here is my code for the initialization of the timer:

     // Interrupt source 53
    vi_counterTimerTest   = 0;
    MCF_INTC_ICR53        = MCF_INTC_ICRn_IL(2) | MCF_INTC_ICRn_IP(7);
    MCF_INTC_IMRH        &= ~MCF_INTC_IMRH_INT_MASK53;
    MCF_SLT_SLTCNT0       = 0xFFFFFFFF;
    MCF_SLT_SCNT0         = 0xFFFFFFFF;
    MCF_SLT_SCR0          = MCF_SLT_SCR_IEN | MCF_SLT_SCR_TEN | MCF_SLT_SCR_RUN;

More precisions :

I put the IT Handler in my vector table, for the number 117 (0x75)
I've corrected the file mcf548x_slt.h (offset for some registers)
I've writen 0x2000 in SR in order to unmask all ITs

Thanks for your help...

Message Edited by ericp on 2007-08-29 08:39 AM

Re: MCF5485 : slice timers

SiE — Fri, 31 Aug 2007 15:20:46 GMT

Hi,

if you want to use the slicetimer 0 you have to use the source 54 not 53. For example MCF_INTC_IMRH_INT_MASK54 instead of MCF_INTC_IMRH_INT_MASK53. If you want to you the source 53 you can use the slicetimer 1.

You can find this information also in the datasheet on page 339.

Re: MCF5485 : slice timers

ericp — Fri, 31 Aug 2007 15:28:48 GMT

Hi,

Thanks for your answer, I saw my mistake yesterday and now it's OK.

bye.