topic Re: Could not set PC to entry point debug error for P&E USB ColdFire Multilink tool in ColdFire/68K Microcontrollers and Processors

Could not set PC to entry point debug error for P&E USB ColdFire Multilink tool

Johnny_zhou — Tue, 21 Nov 2023 09:05:36 GMT

I could not enter into debug mode and there is 'Could not set PC to entry point' pop-up. I also try to debug via NXP website demo AN2892SW. That is same error. It is a old project and debug succesfully before. Debug tool and hardware board is good. I don't know what this error mean. Would you give me some direction to remove it? Thanks.

Debug tool - P&E USB ColdFire Multilink tool

MCU - MCF5234

IDE - Codewarrior V5.7

PC environment - Vmware windows XP

Re: Could not set PC to entry point debug error for P&E USB ColdFire Multilink tool

Bio_TICFSL — Tue, 21 Nov 2023 16:08:56 GMT

Hello,

Is there a way to test this situation without vmware, It seems the computer is confusing about the entry point and where is located.

Regards

Re: Could not set PC to entry point debug error for P&E USB ColdFire Multilink tool

Johnny_zhou — Thu, 23 Nov 2023 09:32:11 GMT

I change try without Vmware. There is no error indication and could enter into debug view. But I could not step into or step over normally. I download demo AN2892SW

In addition, after download demo, there are function redeclaration build error. I undefine redeclaration function and build successfully and debug it not normally. I don't know why? Thanks.