ColdFire/68K Microcontrollers and ProcessorsのトピックI need Help about DEMOEM MCF51EM256 https://community.nxp.com/t5/ColdFire-68K-Microcontrollers/I-need-Help-about-DEMOEM-MCF51EM256/m-p/217561#M11003 <HTML><HEAD></HEAD><BODY><P>Hello</P><P>&nbsp;</P><P>I have a little problem with targert DAMOEM, it's used MCF51EM256 microcontroller, I'm trying to programmer with the example Freescale give, all go so fine I programmed, but when I want to run the example the targert not show nothing, I think that it could be the clock configurated, but I don't know I try too the MCU show me something in Hyperterminal but I tasted the signals and show so fine in oscilocopy, but in the hyperterminal don't show nothing, Somebody could help me with this problem?...&nbsp;</P><P>&nbsp;</P><P>Thaks</P></BODY></HTML> Tue, 10 Aug 2010 04:22:20 GMT andrxs 2010-08-10T04:22:20Z I need Help about DEMOEM MCF51EM256 https://community.nxp.com/t5/ColdFire-68K-Microcontrollers/I-need-Help-about-DEMOEM-MCF51EM256/m-p/217561#M11003 <HTML><HEAD></HEAD><BODY><P>Hello</P><P>&nbsp;</P><P>I have a little problem with targert DAMOEM, it's used MCF51EM256 microcontroller, I'm trying to programmer with the example Freescale give, all go so fine I programmed, but when I want to run the example the targert not show nothing, I think that it could be the clock configurated, but I don't know I try too the MCU show me something in Hyperterminal but I tasted the signals and show so fine in oscilocopy, but in the hyperterminal don't show nothing, Somebody could help me with this problem?...&nbsp;</P><P>&nbsp;</P><P>Thaks</P></BODY></HTML> Tue, 10 Aug 2010 04:22:20 GMT https://community.nxp.com/t5/ColdFire-68K-Microcontrollers/I-need-Help-about-DEMOEM-MCF51EM256/m-p/217561#M11003 andrxs 2010-08-10T04:22:20Z Re: I need Help about DEMOEM MCF51EM256 https://community.nxp.com/t5/ColdFire-68K-Microcontrollers/I-need-Help-about-DEMOEM-MCF51EM256/m-p/217562#M11004 <HTML><HEAD></HEAD><BODY><P>Andrxs,</P><P>&nbsp;</P><P>If you could provide a bit more detail, then I'm sure others on the forum could help a bit.</P><P>&nbsp;</P><P>If you could provide the specific demo and status of any LEDs etc on your board. &nbsp;Also, which devtool you are using etc...</P><P>&nbsp;</P><P>Hope this helps</P><P>JWW</P><P>&nbsp;</P></BODY></HTML> Thu, 12 Aug 2010 03:29:43 GMT https://community.nxp.com/t5/ColdFire-68K-Microcontrollers/I-need-Help-about-DEMOEM-MCF51EM256/m-p/217562#M11004 JWW 2010-08-12T03:29:43Z