S32KのトピックRe: S32K14X MCAL Port Configure and peripheral Code gen Fail

S32K14X MCAL Port Configure and peripheral Code gen Fail

Athai — Fri, 05 Sep 2025 03:26:11 GMT

Hello team,

I’m having some issues with my AUTOSAR LED blinking project.

I followed the HOWTOs to build the project, but I encountered some problems.

https://community.nxp.com/t5/S32-Design-Studio-Knowledge-Base/HOWTO-Create-a-Blinking-LED-example-project-using-S32K1xx-RTD/ta-p/1471695

This is my AUTOSAR RTD Version :

When I configure the MCAL Port, I can’t set the pin status—it always stays at 0 no matter which pin I select.

Also, as you can see on the right side, there are many peripheral code generation errors.

Did I miss a step in the setup?

Re: S32K14X MCAL Port Configure and peripheral Code gen Fail

Robin_Shen — Fri, 05 Sep 2025 04:39:11 GMT

Did you configure the pin in Pins Tool?

After entering the correct PortPin Pcr, you will see the corresponding configuration in the Pins Tool.

Regarding the PortPin Pcr number, please refer to the answer in Mismatch between the PIN configuration

Best Regards,
Robin
-------------------------------------------------------------------------------
Note:
- If this post answers your question, please click the "ACCEPT AS SOLUTION" button. Thank you!

- We are following threads for 7 weeks after the last post, later replies are ignored
Please open a new thread and refer to the closed one, if you have a related question at a later point in time.
-------------------------------------------------------------------------------

Re: S32K14X MCAL Port Configure and peripheral Code gen Fail

Athai — Fri, 05 Sep 2025 05:45:46 GMT

Thank you very much. I am now able to define the pins.
May I ask how to obtain the file AUTOSAR_MCAL_PORT_UM.pdf?

Re: S32K14X MCAL Port Configure and peripheral Code gen Fail

Robin_Shen — Fri, 05 Sep 2025 06:29:24 GMT