S32KのトピックRe: A problem occurred during debugging

A problem occurred during debugging

zenging — Tue, 27 Aug 2024 03:02:25 GMT

After I enter debug, there will be some prompts about the debugger, and then the program seems to be stuck in a certain place, and can not run down.I want to know how to solve it.

Re: A problem occurred during debugging

lukaszadrapa — Wed, 28 Aug 2024 12:17:32 GMT

Hi @zenging

isn't that caused by startup files? What does happen if you uncheck "Run on reset" in Debug configurations like this?

Then it will stop at entry point once the project is loaded and you can debug also the startup files. Can you reach this state or does it crash already during the loading?

Regards,

Lukas

Re: A problem occurred during debugging

zenging — Thu, 29 Aug 2024 01:36:05 GMT

HI,@lukaszadrapa

I uncheck the reset and run options according to your suggestion, but when I click debug, I will jump directly to this error message.

Then when I hit resume multiple times it's stuck inside the DevAssert function. I would like to ask how this situation should be resolved.

Re: A problem occurred during debugging

zenging — Thu, 29 Aug 2024 02:14:09 GMT

This is my creation of the project, you can see if there is any problem.

Re: A problem occurred during debugging

lukaszadrapa — Mon, 02 Sep 2024 05:27:27 GMT

I loaded the project to my board and it seems it works as expected. Are your clock settings correct? Does crystal frequency on your board correspond to the value set in the configurator?

Re: A problem occurred during debugging

zenging — Mon, 02 Sep 2024 06:17:39 GMT

HI,@lukaszadrapa

I'm not sure if my clock is configured correctly because it seems to me that your tutorial didn't teach me how to configure the clock. I just configured the initialization of the serial port. So how do you configure the clock correctly?

This is the crystal oscillator on my board, should I modify the clock initialization according to this crystal oscillator? How should I configure it?

Re: A problem occurred during debugging

zenging — Tue, 03 Sep 2024 09:34:38 GMT

This crystal oscillator is a passive crystal oscillator, do you need any additional configuration

Re: A problem occurred during debugging

lukaszadrapa — Tue, 03 Sep 2024 12:09:32 GMT

I can see in your project that 16MHz is configured. This needs to be updated: