S32KのトピックRe: FLEXCAN_SRV_Seinit

FLEXCAN_SRV_Seinit

zhouqicheng — Tue, 30 Jul 2024 15:07:16 GMT

Hello, sending a 'can' command immediately upon power on will cause a blockage, resulting in the inability to reverse initialize the 'can' command,
tatus_t FLEXCAN_DRV_Deinit(uint8_t instance);
How can I unblock the network and make FLEXCAN_SRV_Seinit work properly,
Sending other instructions with the same baud rate will not result in this situation

Re: FLEXCAN_SRV_Seinit

Julián_AragónM — Wed, 31 Jul 2024 20:06:24 GMT

Hi @zhouqicheng,

Please share some details from your project. Which device is this? Also, are you using an example or is this your code?

Does FLEXCAN_DRV_Deinit return STATUS_ERROR? Please clarify what is meant by "blocked network".

Best regards,
Julián

Re: FLEXCAN_SRV_Seinit

zhouqicheng — Thu, 01 Aug 2024 07:12:46 GMT

Hello, using the official can bootloader program, which is used to jump the app program to exit can, requires CAN_Seinit. If you keep sending the can command, you will be stuck in the/* Wait for entering the freeze mode */function of CAN_Seinit. Other commands will not have this phenomenon

Re: FLEXCAN_SRV_Seinit

zhouqicheng — Thu, 01 Aug 2024 09:15:06 GMT

Hello, I noticed that I am unable to enter freeze mode
NOTRDY and FRZACK bits are both zero
After checking the registers, I still haven't entered low-power mode. Is there any other reason why I can't enter freeze mode? Why don't similar commands have this phenomenon

Re: FLEXCAN_SRV_Seinit

Julián_AragónM — Mon, 05 Aug 2024 20:42:28 GMT

Hi @zhouqicheng,

Please check 55.1.9.1 Freeze mode entry; it describes the steps needed for entering freeze mode:

Best regards,
Julián