S32KのトピックHow to use Freemaster MDBT Simulink

How to use Freemaster MDBT Simulink

ferminzafira — Thu, 14 Mar 2024 13:20:20 GMT

Hi,

I recently bought a s32-k344EVB-Q172 board. I am trying to view the variables with freeemaster. At the time of detecting the board with the freemaster connection wizard, it cannot be found.
I have installed the Simulink MBTD library, the S32 IDE, S32 design studio and S32 design studio extensions, realtime drive for cortex-M and freemaster.

What should I do to be able to connect with her?
Thank you.

Re: How to use Freemaster MDBT Simulink

petervlna — Fri, 15 Mar 2024 06:25:46 GMT

Hello,

Not sure where is the issue from infomation you share. But make sure you have a look at Freemaster community, there is guidance how to make it work.

Basically you will need 2 things. SW with freemaster in micro and installed freemaster interface.

As you are most probably going to tune some motor control aplication you will also need MCAT plugin to freemaster.

https://www.nxp.com/design/design-center/software/development-software/motor-control-application-tuning-mcat-tool:MCATSW

Best regards,

Peter

Re: How to use Freemaster MDBT Simulink

ferminzafira — Mon, 18 Mar 2024 09:52:25 GMT

Do I need to change some jumper? Do I need to install some driver, for example open SDA?

Re: How to use Freemaster MDBT Simulink

petervlna — Tue, 19 Mar 2024 05:58:08 GMT

Hello,

Please follow getting started guide to set it properly:

https://www.nxp.com/document/guide/getting-started-with-the-s32k3x4evb-q172-evaluation-board:GS-S32K3X4EVB-Q172

Best regards,

Peter