Non-Maskable Interrupt S32K146

hamid_abrishami — Sun, 22 Oct 2023 14:01:21 GMT

Hi every one! I used S32k146 with LQFP 144. and I connect a safety function pin to PTD3 and use ( Non-Maskable Interrupt) option but it make a conflict in my software routine. CAN I change this interrupt priority. and use this as a normal interrupt.

Re: Non-Maskable Interrupt S32K146

Robin_Shen — Tue, 24 Oct 2023 02:43:35 GMT

This is the introduction to NMI in the Cortex-M4 Devices Generic User Guide:
A Non Maskable Interrupt (NMI) can be signalled by a peripheral or triggered by software. This is the highest priority exception other than reset. It is permanently enabled and has a fixed priority of -2. NMIs cannot be:
• masked or prevented from activation by any other exception
• preempted by any exception other than Reset.

Have you considered configuring this pin as PTD3 to enable the PORTD interrupt and configure its priority?

Best Regards,
Robin
-------------------------------------------------------------------------------
Note:
- If this post answers your question, please click the "Mark Correct" button. Thank you!

- We are following threads for 7 weeks after the last post, later replies are ignored
Please open a new thread and refer to the closed one, if you have a related question at a later point in time.
-------------------------------------------------------------------------------

Re: Non-Maskable Interrupt S32K146

hamid_abrishami — Sat, 28 Oct 2023 08:29:30 GMT

yes, I config the PTD3 and interrupt function (no NMI function)

topic Re: Non-Maskable Interrupt S32K146 in S32K

Non-Maskable Interrupt S32K146

Re: Non-Maskable Interrupt S32K146

Re: Non-Maskable Interrupt S32K146