S32KのトピックRe: RED and another two LED's are continue ON , not able flash program using openSDA /Jlink to S32K1

RED and another two LED's are continue ON , not able flash program using openSDA /Jlink to S32K14

PU1 — Thu, 05 Oct 2023 07:32:48 GMT

Hi,

Just started working on NXP.

facing some issue in flashing and debugging the code to this EVB .

all other board are working.

IDE : Design Studio for ARM

I am trying to program the S32K146EVB by using openSDA and also with the J-Link debugger

This error pop up.

the RED and Green LED's are always ON .

also tried on MATLAB example same error comes.

Re: RED and another two LED's are continue ON , not able flash program using openSDA /Jlink to S32K1

VaneB — Thu, 05 Oct 2023 21:55:46 GMT

Hi @PU1

Please refer to S32K144 in permanent reset.

Also, could you provide me with the following information?

The imploded code to the devices that starts this behavior.
The steps you realize
Any modifications made to the SW or/and HW

B.R.

VaneB

Re: RED and another two LED's are continue ON , not able flash program using openSDA /Jlink to S32K1

PU1 — Fri, 06 Oct 2023 05:04:52 GMT

Hi @VaneB just tried that method,it not working.

I'm using this EVB for the flashing the code via Embedded coder of matlab and since we are not able to flash the code. so I am trying it on design studio. trying to flash example code. as per your provided link same pulse are received on that point.

Re: RED and another two LED's are continue ON , not able flash program using openSDA /Jlink to S32K1

VaneB — Fri, 06 Oct 2023 19:44:18 GMT

Hi @PU1

Does the board present this behavior from the beginning, or did it start after loading some code?

Re: RED and another two LED's are continue ON , not able flash program using openSDA /Jlink to S32K1

PU1 — Fri, 06 Oct 2023 19:53:29 GMT

Hi @VaneB

From beginning it shows same behaviour.

Re: RED and another two LED's are continue ON , not able flash program using openSDA /Jlink to S32K1

VaneB — Mon, 09 Oct 2023 17:52:21 GMT

Hi @PU1

Just to be sure, did you try the procedure mentioned in the previous shared post using OpenSDA through J7?