Problems debugging with S32 Design Studio v3.4

VictorPastrana — Wed, 23 Aug 2023 22:16:43 GMT

Im experience some problems trying to debug a S32k3X4EVB-Q257 board

I follow the instructions on the Getting Started with the S32K3X4EVB-Q257 Evaluation Board | NXP Semiconductors, also double-check the colocation of the jumpers.

Im using a Segger J-Link Plus to try to debug it (also, i downloaded the Segger Commander just to verify if i can have some device recognition and apparently everything is correct)

Im trying to debug an SDK but im not able to accomplish that.

This is the error.

Here is the debugger configurations

-Just in case this info is needed, im powering the board with external supply 12v.
-On the part of "Device Name", also change from CORTEX M7 to S32K344 and still have the same problem.

Re: Problems debugging with S32 Design Studio v3.4

Robin_Shen — Thu, 24 Aug 2023 06:07:14 GMT

Please refer to S32 Design Studio for S32 Platform V3.4/V3.5 + SEGGER J-LINK Plus

Best Regards,
Robin
-------------------------------------------------------------------------------
Note:
- If this post answers your question, please click the "Mark Correct" button. Thank you!

- We are following threads for 7 weeks after the last post, later replies are ignored
Please open a new thread and refer to the closed one, if you have a related question at a later point in time.
-------------------------------------------------------------------------------

topic Problems debugging with S32 Design Studio v3.4 in S32K

Problems debugging with S32 Design Studio v3.4

Re: Problems debugging with S32 Design Studio v3.4