topic Re: MCSPTE1AK344 code generation in S32K

MCSPTE1AK344 code generation

Albatros — Mon, 29 May 2023 10:31:28 GMT

I tried to generate the MCSPTE1AK344_PMSM_FOC_2Sh_as_tr code from S32DS peripherals and I can see that my motor is working properly in debug mode but when I am done with the debug mode my motor stops working. What causing this problem?

Re: MCSPTE1AK344 code generation

tomasfedor — Thu, 01 Jun 2023 09:01:27 GMT

Hi,

if you want to leave debugging with running target I recommend to use

instead of

Best regards,

Tomas Fedor

Re: MCSPTE1AK344 code generation

Albatros — Thu, 01 Jun 2023 10:24:47 GMT

Okay, it worked, but when I reset my board, my motor was not working again. Do you have any other suggestions?

Re: MCSPTE1AK344 code generation

tomasfedor — Mon, 05 Jun 2023 07:10:15 GMT

Hi,

I have 2 points:

1) verify steps from getting started https://www.nxp.com/document/guide/get-started-with-the-mcspte1ak344-development-kit:GS-MCSPTE1AK344

and I also recommend S32K3 Motor Control Training. You can find there detailed explanation as well as hands on part starting at 33:00 https://www.nxp.com/design/training/s32k3-motor-control-training:TIP-S32K3-MOT-CNT

2) if fault appears you can clear the fault by pressings SW5 and SW6 simultaneously or you can clear fault using MCAT (see "5. FreeMASTER and MCAT user interface" in AN13884 or AN13767).

details about the fault can be found in FreeMASTER tab "Faults & Trips"

Best regards,

Tomas Fedor