S32Kのトピックs32 error starting process

s32 error starting process

s_kim1 — Tue, 31 Aug 2021 09:14:39 GMT

Hello,
I am a developer developing with S32K148.

I ended up using the S32K148 on a new project.

I have installed S32 Design Studio for ARM Version 2.2.
And, I tried to run the S32K148_Project_Hello sample code.

However, an error message occurred as shown in the picture below.

I think the part I set is wrong.

But I don't know what the problem is.

I set it up as pictured below.

Please point out the problem to me.

thanks,

danielmartynek — Tue, 31 Aug 2021 12:05:39 GMT

If you use PE Micro Multilink, you need to use the GDB PEMicro interface.

Please go to Help / Install New Software

Select PE Micro Update side and install the interface

Regards,

Daniel

s_kim1 — Wed, 01 Sep 2021 07:48:32 GMT

I completed the installation, but the problem still occurs.

Please see the picture below.

First, right-click the project and run it as Debug As->S32DS C/C++ Application.

An error has occurred.

Second, I run Debug As->Debug Configurations..

And add Executable: ${cross_prefix}gdb${cross_suffix} and run

It runs fine.

After that, if I try the first method(right-click the project and run it as Debug As->S32DS C/C++ Application.), the same error occurs.

I'm repeating this behavior every time I run it.

It's too inconvenient.

If you additionally run As, an error occurs as shown in the picture below.

Please tell me how to run it as Debug As->S32DS C/C++ Application.

I used CodeWarrior for MCU Version: 11.1 in the past.

CodeWarrior for MCU Version: 11.1 was easy and comfortable to use.

However, the currently used S32 Design Studio for ARM Version: 2.2 is too inconvenient.

please help me.

thanks,

danielmartynek — Mon, 06 Sep 2021 08:49:53 GMT

The S32DS C/C++ Application is not for the S32K MCUs, it is for .exe x86 application apparently.

Please use GDP PE Micro / GDP SEGGER for S32K1xx.

Regards,

Daniel