topic using configtool on S32 Design studio in S32G

using configtool on S32 Design studio

sangrael — Thu, 24 Mar 2022 22:50:52 GMT

Hi NXP,

I am just trying to configure all comms and GPIOs on S32G274A chip using configtool on S32 Design studio.

It says MCU is not selected.

Could you help me out?

Regards,

Sangrae

Re: using configtool on S32 Design studio

asap — Fri, 25 Mar 2022 08:20:40 GMT

Hi Sangrae,

You could open S32DS (ver3.4 or later), create a S32DS application project->select the right core you are using -> add the SDK(RTD) for each of the core (if you are using M7). if RTD not yet installed, please install RTD to S32DS also.

You could refer to the S32G training hub (S32G2 Technical overview) for more detail guide.

Re: using configtool on S32 Design studio

Petro — Thu, 25 Sep 2025 11:40:10 GMT

Same problem with S32K144. The project is created, compiled, and loaded, but ConfigTool it doesn't see the processor target.

Re: using configtool on S32 Design studio

Petro — Fri, 26 Sep 2025 10:46:14 GMT

Where can I get an RTD? It's not in the extension list.