topic Re: S32g serial RCON in S32G

S32g serial RCON

LB666 — Sat, 02 Mar 2024 01:23:41 GMT

I am using the S32G-VNP-RDB2 development board and I would like to test the serial boot. Can you tell me how to proceed?

Re: S32g serial RCON

chenyin_h — Thu, 07 Mar 2024 08:19:51 GMT

Hello, @LB666

Thanks for the question and sorry for the delay

Serial Boot mode enables application code to be downloaded to SRAM.

On S32G2, CAN and UART could be used to support serial boot.

Firstly, set the switches:

Secondly, create serial boot images using IVT tools

You may reference the following link:

https://community.nxp.com/t5/S32G/How-to-create-an-image-for-serial-boot/td-p/1716703

At last, transfer the generated image to the board via UART.

The details are shown from the link below:

https://community.nxp.com/t5/S32G/How-to-boot-an-image-from-uart/td-p/1718722

Hope it helps.

Best Regards

Chenyin

Re: S32g serial RCON

LB666 — Fri, 15 Mar 2024 10:47:05 GMT

Thank you for your reply. This is not the answer I wanted. Perhaps I did not describe my problem clearly. Now, I am redefining my problem and would like to know how to start it on the S32g vnp rdb2 development board through serial EEPROM (at24c02)

Re: S32g serial RCON

chenyin_h — Mon, 18 Mar 2024 09:56:22 GMT

Hello, @LB666

Thanks for the feedback and clarification.

So you may consider the serial RCON, is it right? What is your exact question regarding to it?

You may reference the detailed information in “31.3.2.2.2 Boot from serial RCON“ from S32G3 Reference Manual for this topic.

Best Regards

Chenyin