PFE0 ping issue

Abhiram_m_s — Mon, 23 Jun 2025 10:25:31 GMT

Hello ,
We are using BSPS 43 on Acore and autosar on Mcore
Acore is using pfe0,pfe1 and pfe2 and Mcore is using gmac

When the A-core is booted alone, PFE0 is able to successfully ping external IPs (e.g., 8.8.8.8). However, during a multicore boot (A-core + M-core), the ping fails.

To investigate this, we placed a breakpoint at the Mcu_InitClock() function in the M-core. Interestingly, when the execution is halted at this point, the A-core is able to ping successfully.

I have attached the screenshot below

However, once the M-core is allowed to proceed beyond this breakpoint, the A-core freezes. As shown in the screenshot below

We have also observed that if we introduce a delay of approximately 5 seconds at the beginning of the M-core execution, the A-core is again able to ping successfully.

This further suggests that the issue is likely related to a conflict in clock or peripheral initialization between the cores.

This is not the case with PFE1 and PFE2. It successfully pings during both multicore and just Acore boot.

Could you let us know what the issue might be?

Re: PFE0 ping issue

chenyin_h — Tue, 24 Jun 2025 06:42:14 GMT

Hello, @Abhiram_m_s

Thanks for your post.

From the logs described, it is possibly because there is clock conflict existed between M and A core side, I suggest checking your MCU module settings of the M core side to check if PFE0 clock is touched from M core perspective.

Chenyin

S32GのトピックPFE0 ping issue

PFE0 ping issue

Re: PFE0 ping issue