topic Re: Q: How to set the LIN UART master/slave mode? in S32G

Q: How to set the LIN UART master/slave mode?

liujialu_2024 — Thu, 28 Nov 2024 09:00:19 GMT

On board S32G-VNP-RDB2 with BSP 42.0.

I got the LIN UART device:

FLEX_LIN: /dev/ttyLF2
LLCE_LIN: ttyLF3 ttyLF4 ttyLF5 ttyLF6

then How can I know the LIN port is in Master or Slave mode?

In Linux user space, for example, with tools like stty or some others.

and How can I set the LIN port mode, master or slave?

chenyin_h — Thu, 28 Nov 2024 10:54:55 GMT

Thanks for your post.

From BSP UM, the LINFlexD on S32G is configured to UART mode in the BSP, it is not supported as LIN mode(both master and slave) in the BSP.

As a result, there is no such examples/implementation for your requirement.

Sorry for your inconvenience.

Chenyin

liujialu_2024 — Fri, 29 Nov 2024 07:12:04 GMT

What about LLCE_LIN0 ~ LLCE_LIN3, are they all in UART mode?

chenyin_h — Fri, 29 Nov 2024 09:33:46 GMT

Thanks for you reply.

Yes, they could be configured to be used in UART mode by Linux BSP.

Chenyin

liujialu_2024 — Fri, 29 Nov 2024 11:48:13 GMT

but according to the S32G-VNP-RDB2 sch

S32G-VNP-RDB2_DesignFiles/Schematic/SPF-47440_E.pdf

LLCE_LIN connect LIN Bus PHY chip: TJA1124CHG/0Z.

UART + LIN_PHY?

chenyin_h — Mon, 02 Dec 2024 01:48:07 GMT

Yes, from hardware view, the LIN could be supported, since described clearly from the S32G2 RM and schematic(both LLCE LIN and LINFlexD).

But from BSP perspective, LIN are not officially supported by the BSP software.

Chenyin