VR5510 Power-On & Power-Off issue repeatly

Jerry87 — Wed, 16 Nov 2022 22:44:08 GMT

Hello Sir,

My design is based on NXP’s GoldBox. The only difference is that GoldBox pow-rail is +12V DC, but my design is +14.4V DC as shown in picture below.

However, on my prototypes, we have seen the fact that VPRE_3V3 (IC Pins: 35, 36, 6) is power ON, power OFF, power ON, power OFF etc repeatedly.

My finding:

When we removed C477, this issue can be resolved. So we suspect that there is a timing issue on power on sequence on PWRON1.
In GoldBox, PWRON1 take 5.12ms for rising edge in average; our design is about 7ms for rising edge in average. Could you please let us know what the minimum & maximum rising edge time of PWRON1?
Based on our issue, is there any other points that we need to investigate?

Re: VR5510 Power-On & Power-Off issue repeatly

diazmarin09 — Fri, 18 Nov 2022 15:09:08 GMT

Hello Jerry,

I hope all is great with you.

Please review the response from the PMICs team below:

Please check below plot, we recommend T1>3ms, T2>7ms. Customer can check whether the T2>7ms is met.

Therefore, to power up PWRON12 should wait at least 3ms. Once it is powered up, you should maintain VDDOTP at least 7ms more.

I hope this information helps.

Regards,