MQX Software SolutionsのトピックRe: FRDM-KV31F

FRDM-KV31F

chenqian — Mon, 05 Nov 2018 02:57:11 GMT

How does FRDM-KV31F start learning?
And where to find examples？
And there is an update after downloading the software. Why did it not work well after fifty percent?
It shows that a website is not accessible.

Re: FRDM-KV31F

danielchen — Tue, 06 Nov 2018 05:50:00 GMT

Hi gududexue

Please download SDK for Frdm-kv31f from https://mcuxpresso.nxp.com/en/select

You can download documents for learning.

If you can not download it successfully, you can generate a shared link, and copy and paste that link in the browser to try it again.

The examples is under the folder

SDK_2.4.1_FRDM-KV31F\boards\frdmkv31f

Regards

Daniel

Re: FRDM-KV31F

chenqian — Fri, 09 Nov 2018 08:25:25 GMT

Hi! Daniel Chen

You said that I have found it, and according to the video on (

https://www.nxp.com/products/processors-and-microcontrollers/arm-based-processors-and-mcus/kinetis-cortex-m-mcus/v-seriesreal-time-ctlm0-plus-m4-m7/freedom-development-platform-for-kinetis-kv3x-family-mcus:FRDM-KV31F

) this website, I have made a preliminary study of SDK software, but I have encountered several problems.

Firstly, the following errors are displayed in the following operation,

This error will be displayed in the end.

（Unable to read repository at http://gnuarmeclipse.sourceforge.net/updates/content.xml.
Connection reset）

Then the following errors occur when the development board is subinstalled in the real program.

Re: FRDM-KV31F

danielchen — Tue, 20 Nov 2018 08:19:22 GMT

Hi Gududexue:

From your picture, you are using KDS ide.

I would suggest you select USB Multilink interface and try it again.

I also suggest you use MCUXpresso IDE if possible, since MCUXpresso IDE replaced KDS now.

Regards

Daniel

Re: FRDM-KV31F

chenqian — Wed, 28 Nov 2018 02:53:27 GMT

Hi Daniel:

First of all, thank you very much.

Also, I would like to ask that this development board supports the compilation and download of MATLAB/SIMULINK. However, after I set up his PDF document, there was a problem when compiling and downloading his own model.

I don't know whether it's his own model problem or my setup problem.How should this be solved?（And,I use MATLAB2014a/b）

Regards

Gududexue