MQX Software SolutionsのトピックRe: Debug trouble

Debug trouble

jonnyescobar — Fri, 14 Aug 2015 04:26:16 GMT

I am triying to debug my program, this stop on ldr r0, there is a discussion but the link doesn't work

Thread [1] <main> (Suspended : Signal : SIGTRAP:Trace/breakpoint trap)

__boot() at boot.S:66 0x7cc

the code where happen is:

/* Disable interrupts and clear pending flags */

ldr r0, =NVIC_ICER0

ldr r1, =NVIC_ICPR0

ldr r2, =0xFFFFFFFF

mov r3, #8

thanks a lot

soledad — Fri, 14 Aug 2015 19:41:56 GMT

Hello Jonny,

Are you using MQX??

Which device are you using??

Which IDE are you using?

Regards

Sol

soledad — Fri, 14 Aug 2015 19:45:23 GMT

Regards

Sol

jonnyescobar — Sat, 15 Aug 2015 00:40:43 GMT

Hello

I am using MQX, k64FN1M0VLQ12 and KDS 3.0, my board was worrking but i did minor changes on Processor Expert GPIO configuration.

Thanks

soledad — Tue, 01 Sep 2015 22:46:21 GMT

Hello Jonny,

Please check the link below and let me know if this helps.

Regards

Sol