FRDM-MCXA156 : How to Add SEGGER SystemView to MCUXpresso IDE

Puneeth1 — Wed, 10 Dec 2025 15:41:05 GMT

HI ,

I am working with the FRDM-MCXA156 development board and MCUXpresso IDE.
I need to integrate SEGGER SystemView into my project, without reflashing the MCU-Link to J-Link firmware.
I want to use single-shot / post-mortem mode (capture trace into RTT buffer in RAM, then manually extract it after halting the MCU).

Could anyone please share the procedure for the same.

Re: FRDM-MCXA156 : How to Add SEGGER SystemView to MCUXpresso IDE

Habib_MS — Fri, 12 Dec 2025 20:17:05 GMT

Hello @Puneeth1,

There is no official guide for what you are asking, but you can use these documents as references:
These will help you configure SystemView properly:

FreeRTOS V10.4.1 with SEGGER SystemView V3.12 | MCU on Eclipse

How to Use SystemView Data Plot Feature for Real-time Data Visualization | MCU on Eclipse

Additionally, in this community post you can find a code example showing how to incorporate SystemView for a version of MCUXpresso.

And here is the official SEGGER documentation for single-shot / post-mortem mode.

Single-Shot Recording for embedded systems testing | SEGGER SystemView

BR
Habib

topic FRDM-MCXA156 : How to Add SEGGER SystemView to MCUXpresso IDE in MCX Microcontrollers

FRDM-MCXA156 : How to Add SEGGER SystemView to MCUXpresso IDE

Re: FRDM-MCXA156 : How to Add SEGGER SystemView to MCUXpresso IDE