Layerscape中的主题 LS1046ARDB RTIC Throttle value

LS1046ARDB RTIC Throttle value

Faizanbaig — Tue, 16 Nov 2021 11:49:36 GMT

Hi ,

I am trying to configure RTIC(Run time integrity Checker) on LS1046ARDB board. I want to set RTIC throttle register but I did not find any reference values for setting the Throttle value . Is there any additional document other than Trust2.1 and SECRM manual that can help us in deciding the throttle value?

Any suggestions would be appreciated.

Thanks,

Faizanbaig

Re: LS1046ARDB RTIC Throttle value

yipingwang — Thu, 18 Nov 2021 02:27:54 GMT

RTIC throttle register is to define how many SEC engine clocks to wait to launch the next descriptor to hash the next block of data. This is used to keep RTIC from using too much bus bandwidth.
So it depends on your use case and whether you are using the SEC engine for other operations (e.g. IPsec, VPN, TLS, etc).
I will suggest initially set RTIC Throttle (RTHR) at 0x176001c to 0xff000000, and adjust the value accordingly to your use case.

Re: LS1046ARDB RTIC Throttle value

Faizanbaig — Thu, 18 Nov 2021 05:29:37 GMT

Thank you.

Could you please respond on https://community.nxp.com/t5/Layerscape/RTIC-Configuration-on-LS1046ARDB/m-p/1372745#M9398

Re: LS1046ARDB RTIC Throttle value

Faizanbaig — Tue, 05 Dec 2023 15:24:34 GMT

Hi,
In this "set RTIC Throttle (RTHR) at 0x176001c to 0xff000000" what does 0xff000000 means?