LS1028A:Network file configuration while system bootup

gouravjain — Thu, 20 Jul 2023 10:54:42 GMT

Hi All,

Can some one pls guide me where to configure ethernet ip address for eth0 port so system will preserve the ip address after boot up.

regards,

Gourav Jain

Re: LS1028A:Network file configuration while system bootup

yipingwang — Fri, 21 Jul 2023 08:02:36 GMT

I assume that you are using Ubuntu rootfs filesystem.

To configure your system to use static address assignment, create a netplan configuration in the file /etc/netplan/99_config.yaml. The example below assumes you are configuring your first Ethernet interface identified as eth0. Change the addresses, routes, and nameservers values to meet the requirements of your network.

network:

version: 2

renderer: networkd

ethernets:

eth0:

addresses:

- 10.10.10.2/24

routes:

- to: default

via: 10.10.10.1

nameservers:

search: [mydomain, otherdomain]

addresses: [10.10.10.1, 1.1.1.1]

The configuration can then be applied using the netplan command.

sudo netplan apply

LayerscapeのトピックRe: LS1028A:Network file configuration while system bootup

LS1028A:Network file configuration while system bootup

Re: LS1028A:Network file configuration while system bootup