topic Re: Trigger A & B occurred?? in 8-bit Microcontrollers

Trigger A & B occurred??

HarrySun — Sat, 10 Mar 2007 04:00:31 GMT

in CW debugger, it sometime shows "Trigger A & B occurred"

what does it mean??

thanks

Re: Trigger A & B occurred??

CrasyCat — Mon, 12 Mar 2007 18:36:20 GMT

Hello

That message is generated when you have enabled some triggers on the DBG module.

In the connection menu (MultilinkCyclonePro, GDI, .....) select "Trigger Module Settings".

There are probably some triggers defined in the Trigger settings tab.

Delete the triggers if you do not want to see the message again.

CrasyCat

Re: Trigger A & B occurred??

joerg — Mon, 12 Mar 2007 19:44:00 GMT

Hi
or you have triggered an interrupt but the vector setting is not correct! I.E. there was an TIM OC interrupt but you have forgoten to set the VECTOR x (in the prm file) to your interrupt routine.

Saluti Joerg

Re: Trigger A & B occurred??

YeOldeBDM — Mon, 12 Mar 2007 20:57:10 GMT

I have seen this message when the power on the target is interrupted, or the bdm connection is intermittent.