8-bit MicrocontrollersのトピックRe: MC13213 with an external LNA

MC13213 with an external LNA

Spell — Thu, 20 Sep 2007 19:56:00 GMT

Hi all,
I need to improve the range coperture of my custom board based on MC13213.
I'm thinking to use an external LNA, like MBC13720, to increase the output power.
Someone have implement a custom board with this kind of device?
I have already asked to Freescale support but they haven't an application note with this device or a reference manual.

best regards, Filippo

Re: MC13213 with an external LNA

ZigBeeficator — Fri, 28 Sep 2007 19:27:10 GMT

Hello,

In order to use an external LNA with MC13213, please make sure you are in Dual Port Antenna configuration (see MC1321x datasheet), then here is attached a suggested schematic with MBC13720 LNA.

Regards

MBC13720_design.pdf

Message Edited by t.dowe on 2009-10-27 02:06 PM

Re: MC13213 with an external LNA

Spell — Mon, 01 Oct 2007 14:11:42 GMT

Hi ZigBeeficator,
thank you for your design.
It's possible to use an external LNA like MBC13720 with a Single Port configuration and use the CT_Bias pin for set the LNA in bypass mode or gain mode?
In this case I don't use the Dual Port Configuration like you have suggested.

best regards, Filippo

Re: MC13213 with an external LNA

rfquery — Wed, 26 Mar 2008 16:49:26 GMT

Hi all,

Suppose I am using MBC13720 ( a seperate board) with MC13213 board to extend the range( after doing some board rework ) what type of connectors and cables should I use to avoid impedance mismatch?

Re: MC13213 with an external LNA

Spell — Wed, 02 Apr 2008 17:33:01 GMT

You can use any kind of connector and cable with an impedance of 50ohm at 2.4GHz

Re: MC13213 with an external LNA

muni — Fri, 25 Jul 2008 13:07:09 GMT

Hi friends,

If anybody has single antenna schematic for MC13213 (ZigBee modem) with MBC13720(LNA) in tranmit path, please share it with me. Also, I would like to know with this LNA what could be the max range I can achieve.

Thanks in advance.

Regards,

Muni.

Re: MC13213 with an external LNA

muni — Fri, 25 Jul 2008 13:09:03 GMT

Hi,

Could you share your schematic which has LNA MBC13720 interfaced with MC13213.

Thank you.

Regards,

Muni.

Re: MC13213 with an external LNA

rfquery — Fri, 31 Oct 2008 18:05:21 GMT

Hi all,

Would anyone please share what is the minimum SNR required for detection and the Noise figure for Freescale MC13213 SRB board. This is needed to calculate (theoretically) by what factor the range can be extended by using an LNA with SRB.

Thank you.

Regards.

Re: MC13213 with an external LNA

rfquery — Fri, 07 Nov 2008 17:25:31 GMT

Hi,

Would anyone please share the calculation of external matching components values (Inductors and capacitors ) of MBC13720 for 1.9GHz and 2.4GHz operation.

Thank you.

Regards,