GPIO interrupt problem for MC9S08SH8 8 bit microcontroller

senthilkumar — Fri, 13 Dec 2013 05:39:30 GMT

Hello,

I am working DEMO9S08SH8 development board with CW V6.3.

My GPIO interrupt is not working. my code is ,

void main()

{

PTBSC_PTBIE = 0; // Disable interrupt

PTBPS_PTBPS0 = 1; // PortB, bit-0 is enabled for interrupt

PTBSC_PTBMOD = 0; // edges only

PTBES_PTBES0 = 0; // interrupt on falling edge

PTBSC_PTBACK = 1; // acknowledge flag

PTBSC_PTBIE = 1; // enable interrupt

PTBDD_PTBDD0 = 0;

EnableInterrupts;

for(;;)

{

;

}

interrupt 21 void PORTB_ISR(void)

{

PTBSC_PTBACK = 1; // acknowledge flag

}

Please any one help me

Re: GPIO interrupt problem for MC9S08SH8 8 bit microcontroller

egoodii — Mon, 23 Dec 2013 23:41:24 GMT

We will assume you've got Vector 21 (at the active vector table address) pointing to PORTB_ISR.

I would clear PTBDD_PTBDD0 earlier, and set PTBPS_PTBPS0 next-to-last, after all setup steps.

You need to make sure none of the modules defining 'alternate functions' for that pin are turned on, specifically SCI disabled (SCIC2_RE cleared OR SCIC1_LOOPS set) and also ADPCTL1_ADPC4 is cleared.

8-bit MicrocontrollersのトピックGPIO interrupt problem for MC9S08SH8 8 bit microcontroller

GPIO interrupt problem for MC9S08SH8 8 bit microcontroller

Re: GPIO interrupt problem for MC9S08SH8 8 bit microcontroller