P&E USB Multilink Issue

IanM — Wed, 17 Jan 2007 01:23:00 GMT

Hello,

I am using the P&E Multilink debugger to prog my MC9S12X micro, when the micro is in selt clock mode all is fine and I am able to prog and debug no problem. However when I connect and enable the 16MHz XTAL my down load fails with a message "ELF Loader : Error while writing to FFFE..101FE" followed by "HI-WAVE: Failed to load "C:\projects\X Gate\xCAN Test\bin\P&E_Multilink_CyclonePro.abs" The command output on the True-Time Simulator gives

     MCU clock speed: 8008000 Hz
Block Module Name      Address Range   Status
  0 FLASH_4000        4000 - 7FFF   Blank - Unselected
  1 FLASH_C000        C000 - FFFF   Blank - Unselected
  2 PAGES_E0_E7     E08000 -E7BFFF   Blank - Unselected
  3 PAGES_F8_FF     F88000 -FFBFFF   Programmed - Unselected
  4 EEPROM_C00         C00 -   FFF   Blank - Unselected
  5 ALL_EPAGES      FC0800 -FF0BFF   Blank - Unselected
  6 EEPROM_800         800 -   BFF   Blank - Unselected
  7 FLASH_8000        8000 - BFFF   Programmed - Unselected

Also I can see the 16MHz signal a scope no problem.

Thanks in advance

Re: P&E USB Multilink Issue

Bee — Sun, 28 Jan 2007 11:56:37 GMT

I assume that you have your communication speed set up to be Auto-Detect or that you set the "clock divider" value to 14. I've had trouble when I forget to set the speed up. HTH.

Re: P&E USB Multilink Issue

IanM — Mon, 29 Jan 2007 16:28:16 GMT

I sure do have these settings, thanks for the post back.:smileyhappy

S12 / MagniV Microcontrollers中的主题 Re: P&E USB Multilink Issue

P&E USB Multilink Issue

Re: P&E USB Multilink Issue

Re: P&E USB Multilink Issue