topic How to generate a CAN Bus-Off Condition? in S12 / MagniV Microcontrollers https://community.nxp.com/t5/S12-MagniV-Microcontrollers/How-to-generate-a-CAN-Bus-Off-Condition/m-p/142321#M3424 <HTML><HEAD></HEAD><BODY><DIV>I am connecting my MC9S12DG128 based board to the Vector CANalyzer to check my CAN transmission.</DIV><DIV>If I stop receiving the frames on the CANalyzer, then registers in the microcontroller, indicate that an "Error Passive" state has been reached.</DIV><DIV>The problem I am facing is - Using this setup, I am unable to generate a Bus-Off Condition. The CAN controller in the microcontroller gets stuck at the Error Passive state, when I stop receiving the frames.</DIV><DIV>&nbsp;</DIV><DIV>Any inputs why this happens and how do I generate a Bus-Off condition?</DIV></BODY></HTML> Wed, 10 Jan 2007 20:38:24 GMT pammu 2007-01-10T20:38:24Z How to generate a CAN Bus-Off Condition? https://community.nxp.com/t5/S12-MagniV-Microcontrollers/How-to-generate-a-CAN-Bus-Off-Condition/m-p/142321#M3424 <HTML><HEAD></HEAD><BODY><DIV>I am connecting my MC9S12DG128 based board to the Vector CANalyzer to check my CAN transmission.</DIV><DIV>If I stop receiving the frames on the CANalyzer, then registers in the microcontroller, indicate that an "Error Passive" state has been reached.</DIV><DIV>The problem I am facing is - Using this setup, I am unable to generate a Bus-Off Condition. The CAN controller in the microcontroller gets stuck at the Error Passive state, when I stop receiving the frames.</DIV><DIV>&nbsp;</DIV><DIV>Any inputs why this happens and how do I generate a Bus-Off condition?</DIV></BODY></HTML> Wed, 10 Jan 2007 20:38:24 GMT https://community.nxp.com/t5/S12-MagniV-Microcontrollers/How-to-generate-a-CAN-Bus-Off-Condition/m-p/142321#M3424 pammu 2007-01-10T20:38:24Z Re: How to generate a CAN Bus-Off Condition? https://community.nxp.com/t5/S12-MagniV-Microcontrollers/How-to-generate-a-CAN-Bus-Off-Condition/m-p/142322#M3425 <HTML><HEAD></HEAD><BODY><DIV>I am using CAN, but on 56800 series. Excuse my ignorance, but is your CAN peripheral a FlexCAN? And are you using Processor Expert?</DIV></BODY></HTML> Fri, 19 Jan 2007 23:57:47 GMT https://community.nxp.com/t5/S12-MagniV-Microcontrollers/How-to-generate-a-CAN-Bus-Off-Condition/m-p/142322#M3425 AgentK 2007-01-19T23:57:47Z