here is my problem i configured dma channel 0 on pdb request and in this transfer i configured ADC0 SC1A register so it generate a soft trigger to begin adc0 conversion.
In the other hand i configured dma channel 1 on ADC0 COCO request to transfer data from ADC0 RA to a buffer i created.
So regarding to this configuration i expected to have one conversion after each PDB request.
To check this i configured a dma channel1 interrupt and i set then reset a pin to see a pulse at the oscilloscope each time a conversion is complete.
here is my problem i got a continuous train of pulses that are not synchronized with the pdb request so i checked the adc0 and it is not configured in continuous mode so i didn't understand why i didn't have the desired behavior.
Can anyone help me please.