AnsweredAssumed Answered

i.MX8MM USB2.0 Design Without USB TYPE-C

Question asked by Dudi Sasson on May 12, 2020
Latest reply on May 15, 2020 by Wigros Sun



I`m designing a new base board using the IMX8MM EVK. i plan to connect a UVC camera directly to USB1 (without a connector).

i followed the instruction below but i am not sure about IOMUX part, what do i need to change in the device tree?

IMX8MM EVK Type C connector 


also, the USB_OTG_ID pin is currently used for the ETH, what do i need to change in order to use the USB_ID instead?